since no 1 answered other thread here's question fitting 3.1 logic board 1,1 case..
guys have question..you cut 2 pin wires (7 , 2 ps3) , solder them 2 , 9 pin on ps2..however, there wires on 2 , 9 ... add 2 wires wires, end 2 wires on 2 pins (ps2) oh, can't cos both ground wires...
in other words can explain better ie: cut wires 2 wires on pin 2 , 9 , leave them loose (ps2 loom end)..then cut ones on pin 2 , 7 (ps3) , solder them pin 2 , 7 ps3 connector (from pins end or harness end) , leave cut wires @ loom end (not @ plug end go ps2 connector) loose (not connected @ pins), in other words..do pin 2 , 7 soldered ps2 connector. oh, on ps3 connector leave pin 2 , 7 not connected (it's bit hard explain in text)....
see, i'll rather go way... because it's easier me removing 1,1 harness , fitting 3,1 harness, lot of work , shorter too...
quick, come suggestion, before op starts thread same question.
looks might on own one.
Forums Macs Desktops Mac Pro
- iPhone
- Mac OS & System Software
- iPad
- Apple Watch
- Notebooks
- iTunes
- Apple ID
- iCloud
- Desktop Computers
- Apple Music
- Professional Applications
- iPod
- iWork
- Apple TV
- iLife
- Wireless
Comments
Post a Comment